Congrats to our New President Anguss!!
Remember to like us on Facebook!! - https://www.facebook.com/skylinesdownunder

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mŮk

Pages: [1] 2
1
General Skyline Discussion / Plaztek
« on: May 01, 2006, 11:59:50 PM »
Does anyone know if Plaztek are still in business and how to get hold of them. Thanks

2
Maintenance & Car Care / Non genuine nissan parts?
« on: November 16, 2003, 02:40:16 PM »
Does anyone know if you can get rear tie rod end ball joints that go on the hicas that aren't factory nissan ones (as in not $550 for four ball joints) and also if you can get a new bearing for the J arm at the front instead of a whole new arm? cause my car failed its warrant on them and i can't really afford nearly $900 for four ball joints and a bearing. Its a R32 gts-t.
Thanks

3
Maintenance & Car Care / Crazy manual computer?
« on: July 19, 2003, 01:07:14 AM »
I got a manual computer today cause i converted my car from auto to manual a while ago, but when it was all plugged in as soon as i turned the ignition on it kept on constanly flashing out codes 23 and 45. It did it when the engine was running as well and it wasn't in diagnostics mode either. The computer i got has the 2 leds (red and a green one) but my old auto one only has one and the manual ones mounting points were slightly different. Does anyone know what could be wrong?
The cars a r32 gts-t
Thanks
Mark

4
General Performance / Has anyone put V6 holden coils on?
« on: December 29, 2002, 01:01:57 AM »
Has anyone put Holden V6 vn onwards coils on their skyline? are they any good? i assume they would be more reliable than the skyline ones since they dont get heated up as hot? cause i might put them on my skyline to get rid of the dieing coils

5
Maintenance & Car Care / Airflow meter
« on: October 26, 2002, 11:39:22 PM »
I pulled my airflow meter out today and it was a RB25 one out of a C34 Laurel. My cars a rb20det and i am having trouble with my car surging missing and detonating and wondered if the afm was causing one or more of the problems. Does these afms work properly with the rb20 computer?
Thanks

6
Maintenance & Car Care / Speedo reading out
« on: October 15, 2002, 11:09:13 PM »
I have just done a manual conversion on my r32 gts-t and the speedo is not reading right. At about 2500 in 5th the speedo reads 120-130kph. I pulled the speedo drive out the manual and it had 16 or 17 teeth and the auto one has 25 so i thought i would put the auto one in but it was too big. What could i do to get it reading properly? Also what wires do i hook up for the speed sensor thing?
Thanks

7
General Performance / Wiring?
« on: October 09, 2002, 10:31:43 PM »
For the manual conversion wiring i know to bridge the big black and brown wires but what are the rest for? my manual gearbox has two plugs off it i think ones for reverse and one for speed sensor thing? what wires do i need to join up?

8
Maintenance & Car Care / Wheres a Good Skyline mechanic in auckland?
« on: September 06, 2002, 10:08:33 PM »
Where would be a good place to take my skyline to get its problems sorted round the auckland area? It would need to be someone who new a bit about skylines cause so far the people who i have taken it to just say: i don't know what that sound is it could be the big end bearings or sounds like detonation check the ignitor and coils and stuff:confused:
thanks

9
Forced Induction / Will a GTE manual driveshaft fit a GTS-t
« on: September 06, 2002, 10:51:41 AM »
would a gte manual driveshaft fit a rb20 manual box?
thanks

10
Maintenance & Car Care / Does it fit?
« on: August 12, 2002, 08:36:10 PM »
Does the auto gearbox rear mount fit on the manual geabox cause the box i got didnt have the rear mount on it?
thanks

11
Maintenance & Car Care / Timing and other problems
« on: August 06, 2002, 09:54:35 PM »
My gts-t sounds like it is detonating when you put your foot down from lower revs. It standard and it is on 96 Because there is no 98 round here. Does anyone know what timing it should be at for 96? It had another motor put in about 3 months ago because the old motor snapped its cambelt after about 2000kms.

Also it surges when boosting  when up round 5000rpm and above it feels like it drops off boost for a second then comes back on again and going up the passing lane it started shuddering like it was only  running on 4 or something, i could hardly get past anything, it couldn't even keep up with my friends gtz trueno and when it was doing this my friend said it was making LOUD ticking noises.
Thanks

12
Does anyone know what the torque settings for the flywheel bolts are and how much a spigot bush/bearing is for a RB20 manual and where i could get one?
Thanks

13
Stagea - the Skyline wagon / Found a Stagea 260RS for sale in japan
« on: July 23, 2002, 10:37:14 PM »
Its a 1998 manual 260RS thats the one with a RB26 in it for 2890000

14
General Performance / S13 clutch pedal box in R32?
« on: July 11, 2002, 08:22:30 PM »
Does anyone know if a S13 Clutch pedal box will fit in a r32. And does a R33 one fit?
Thanks

15
General Performance / Manual Gearbox Differences?
« on: June 29, 2002, 10:19:47 PM »
How do you tell the difference between a RB20DET manual gearbox and other non turbo RB20 manual gearboxs or is there no difference
Thanks

Pages: [1] 2