Congrats to our New President Anguss!!
Remember to like us on Facebook!! - https://www.facebook.com/skylinesdownunder

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jade501

Pages: [1] 2
1
Australia / sending car to aus
« on: January 21, 2013, 08:30:28 PM »
hey guys just woundering if anyone has sent there car from nz to aus and got it on the road ???

2
Picture Post / my r32 skyline
« on: May 22, 2012, 04:59:19 PM »

3
General Skyline Discussion / boosh #3737 5 wire wide band o2 sensor
« on: May 10, 2012, 06:19:18 PM »
i have a wide band o2 sensor now what does the lc1 that plugs into wide band do?? and do i need it cheers

4
General Performance / ignitor wiring
« on: April 30, 2012, 07:07:17 PM »
ok i have look on net 4 ages now im wiring up 3 coils (wasted spark) into my aftermarket comp thats easy but wanting to double check the wiring of the ignitor powers earths etc its just the standard ignitor cheers

5
General Performance / rb26det oil feed
« on: March 18, 2012, 09:01:45 PM »
turbo feed im looking 4 a good oil feed kit i have a rb26det with a garrett t3t4 turbo oil cooled only cheers

6
General Skyline Discussion / how to wire up twin boosh pumps
« on: February 19, 2012, 08:10:28 PM »
hi i have 2 044 boosh fuel pumps in boot was woundering how to wire up do i just them up to switch but wanting to run as high as voltage as possible and dont realy want to have a switch i have to turn on everytime i start car??

7
General Skyline Discussion / 4wd gts
« on: November 19, 2011, 10:02:44 AM »
well im back from aussy and i have to start my build was looking 4 forums is it possible to convert gts to 4wd??

was planning on buyn a crashed gts4/gtr fire wall cut out to fit gtr gearbox and transfer case and driveshaft in??

8
General Performance / skyline build questions??
« on: September 23, 2011, 07:56:05 PM »
hi guys

i have a very long term rb30det build but i want it to be perfect money not realy a problem but i want it does once proply, plans are
a fully forged spool kit
arp stud
arp bolts
balance crank,crank collar
n1 oil pump
n1 water pump
port and polish head
cams ( no idea which yet)
in lifter,valves,springs
g4 extreme(oil sensors boost sensors and whatever else)
oil head drain
oil cooler relocater

what i want to now and get your guys ideas on is n1 oil pumps, and oil head drain

and relibility is what im going for not so much power also using 25det neo head and how can i make sure i get no failure

cheers

9
General Skyline Discussion / cheers racefab NOT RECOMENED
« on: June 28, 2011, 08:54:40 PM »
bought 1 of these

http://www.racefab.co.nz/intakemanifolds.html

and racefab f**ked it up they didnt drill holes square or str8 so had to take to a proper engineer to fix up and found out today they had to fill in holes n retread now to buy cost $400 n to fix cost $650

anyone now how i could get any money out of him??

10
General Performance / waste gate choice??
« on: June 12, 2011, 11:11:09 AM »
hks 60 or 50 mm
tail 38mm
turbosmart 38mm

on a prety worked 25det build has gt35.40 etc is 50mm or 60mm to big??

11
General Performance / building big fuel pump set up
« on: May 22, 2011, 06:33:32 PM »
building a big fuel pump set up using
-2x 044 bosch external fuel pump
-2x fuel filters  (Fuel Filter - High Flow EFI Inline -6)
-square surge tank

wanting to look like this link, but i am wanting a set up that i never have to change i will be running about 350hp at the moment but 1day might want to run 600hp +, i was woundering what braided fuel lines i should use
ALSO IF ANYONE HAS A BETTER IDEA CHEERS



http://www.trademe.co.nz/Trade-Me-Motors/Car-parts-accessories/Performance/Fuel-systems/auction-377632264.htm

12
General Performance / hks 30.40 vs garrett 30.40??
« on: May 06, 2011, 10:56:19 PM »
wat is better?? for a rb25det neo few liltle mods

13
General Performance / hitting the master cylinder
« on: May 03, 2011, 09:39:06 PM »
has any one had this problem and what did u do??
can u remove the top bottle and run a different system??
i seen a laurel in a mag and didnt have the master cylinder and said on spec it had a ( quater master floating hydraulic release beariung)

14
has anyone done this on a rb25det neo as i have been talking 2 raceshred and they where saying best thing to do as the rb25det neo cam angle are usless and change degrees to often

15
General Performance / afm
« on: April 27, 2011, 07:58:09 PM »
best afm u can use for 25dets or 30dets

Pages: [1] 2