Congrats to our New President Anguss!!
Remember to like us on Facebook!! - https://www.facebook.com/skylinesdownunder

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zanthiath

Pages: [1] 2 3
1
General Skyline Discussion / R34 chase on queen street
« on: April 29, 2011, 06:26:45 PM »
Anyone missing a white r34 couPe pretty sure was a gtt.
Came hauling down queen street tooting thru a pedestrian
Crossing then 10 seconds after two cop cars after. Few seconds after
Police dog wagon. Lil bit after another cop car and two bikes.
Totaled 6 cop cars 2 bikes and 2 dog utes.
They stopped at brito mart but didn't walk down fast enough to
See why. Had the dog out tho but no car.
Was at about 5:40 tonight. Also heard the helicopter
But didn see it
Hope they got the scum.

2
Gaming / GT5 Controller
« on: January 13, 2011, 12:27:48 PM »

3
General Performance / Link G4 extreme lem
« on: January 05, 2011, 05:01:33 PM »
Does anyone by chance have a Link G4 extreme wirein that we could by chance quickly borrow to test to see if the one we are trying to get working is ok??
Its a red Extreme. USB cable as well to elimante problems
Auckland area be easiest.
Having problems with ecu not holding power to stay on.

4
General Performance / Where to get nismo fuel filters from?
« on: November 14, 2010, 04:18:34 PM »
Have a nismo fuel pump for my 180 and currently has a GTR filter on it which doesnt quite work properly.
Anyone know best place to get another??

5
General Skyline Discussion / Swap long for short throttle cable
« on: October 26, 2010, 09:27:45 PM »
I currently have a fwd facing plenum length throttle cable in my car and now
run the 6 throttle setup so am after a much shorter, or even a rb26 throttle cable if anyone would like to swap.
Cheers

6
Powered by Skyline / My 180 Build
« on: July 07, 2010, 06:30:51 PM »
My rs13 with a rb25det
Its not a r33 engine but a built up r32 rb25de
How it looked before i got it, purchased it as a shell

Cut out the rear guards for big feet

Fully redid the doors with sealed components


Fitted rear wing as want some traction

Fitted rear 8" speakers were subs but vibrated to much
New wheels 295 rear


Manifold made

Custom gearbox crossmember

Added a brace like the nismo type and depowered the steering rack

7
General Skyline Discussion / RB Highrise manifold
« on: July 28, 2009, 07:38:49 PM »
Thought id put some pictures up of my manifold in progress.
Its a 4mm Steam Pipe high rise manifold.
Will be having a gt3076r on top with a tial 44mm gate.
Has been done By Tim a TTT Engineering.
Wicked fabricator if anyones lookin for one in the Auckland area.








Going into this

8
General Performance / What to set fuel pressure to?
« on: July 16, 2007, 08:29:34 PM »
Cant find a definate answer.
Currently have it set to 50psi vacuum line off.
and sets itself to 38psi to when attach vacuum line.
What i wanna know what do it set it to.
It still fuel clouds at this setting
Sard fuel press reg

9
General Performance / 9.5mm lift cams into rb25de(t) build
« on: June 24, 2007, 09:17:29 PM »
Just a question
My head has been gettin some work
A r32 rb25de.
9.5mm 270 deg cams have been put into it and the head has been
done in order to accomondate them.
With a metal 1.3mm head gasket onto a rb25de block with ross racing pistons
can i be assured i will be clear of the valves from the pistons??

10
General Performance / Comments on Car Tune - Hamilton
« on: June 01, 2007, 06:44:53 PM »
Just wanting some input and comments on Car Tune's Tuning?
Still new on the Hamilton performance front and they
are the Link retailer.
Going to Install a LinkPlus G3 into my Laurel

11
Powered by Skyline / Peoples Views on Gen3Link
« on: April 25, 2007, 09:22:31 PM »
Just wanting peoples opinions on this ecu.
As ive been building my engine, its progressed further then a basic build.
I was just going to chip her again, but am thinking of aftermarket ecu after run in.
Just lookin for peoples opinions.

12
General Performance / Can u run a r33 25det off a 32 rb20de loom?
« on: January 24, 2006, 07:32:27 PM »
As title sugests, can you run the r33 rb25det on the rb20de loom from the r32 era.
Just wondering which engine route i should take, and if this works easily, may repower with a rb25 and 32 gts-t rechipped ecu.
Cheers

13
General Performance / Who can mount my bov on alloy piping?
« on: October 25, 2005, 05:57:00 PM »
Just wondering who can mount my bov on my alloy intercooler piping??
Ive switched from over the top piping to front facing t/b and need to mount
the bov on the piping?? In auckland would be much preferred

14
General Performance / gt-r resistor pack 4 rb20det??
« on: October 24, 2005, 10:15:55 AM »
Ok, ive searched and havent found where to get them from
Where can i buy the link ballast resistor packs for the gt-r injectors
to go into my rb20det??
Or something similar to use?

15
Picture Post / C33 Laurel
« on: August 26, 2005, 09:56:36 AM »
My little laurel.
Currently supporting the Rb20det, as it will stay
Mods: Rb25 turbo, running factory 0.5 bar
Trust 3 1/2 inch exhaust, 3 inch front pipe, aftermarket dump pipe
Apexi Fmic, Pod filter
500hp Fuel pump
K's rom chipped r3gts-t ecu
Apexi Safc II, untuned yet
Manual 5spd conversion
Full gts-t brake upgarde, and rear subframe, pineapples.
17x8 front(235/40), 17x9 rear(235/40) 255 soon, custom flared guards.
Dobison superlow springs, front and rear strut braces.
RIPS, rear camber and toes arms, front caster arms.
No aircon or abs, running wasted spark insted of coils.
Gt-r front rear seats, full sound system(134db), tints.
has done a 14.6 so far with like -5 degree of camber, now has -0.15 in the rear.
Future mods:
Rb20de compression, RIPS plenum, 444cc injectors and 1 bar boost.
She's my toy and keeps me busy.
Its the baby engine of Team Sleeper

Pages: [1] 2 3