Congrats to our New President Anguss!!
Remember to like us on Facebook!! -

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - 30ed32

Pages: 1 [2] 3 4 ... 33
General Performance / Re: GTS4 R32 to RB25det (retaining 4WD)
« on: October 14, 2015, 07:51:44 PM »
Your research is correct its easiest to get a stagea 4wd 25det or atleast the block anyway as your sump will bolt on

General Performance / Re: rocker cover gaskets
« on: May 28, 2015, 06:34:50 PM »
It's best to use sealant on the half moons, that's where you're most likely to leak

« on: May 26, 2015, 09:25:20 PM »
illegal can't cert it

Maintenance & Car Care / Re: R32 GTR vs GTS4 Diff
« on: January 28, 2015, 10:22:18 PM »
If you mark it with a vivid or one of those white pens and then turn and see how far it goes past it's pretty easy a 4.3 will go quite far away from that mark compared to the 4.1, it almost goes 1/3rd a turn.  If you just imagine it and split it up into quarters and it goes past the first quarter (which is 4.25) then you know what it is.

Maintenance & Car Care / Re: R32 GTR vs GTS4 Diff
« on: January 28, 2015, 10:00:40 AM »
Count the ratio GTR is 4.1:1 and GTS4 4.3:1

Picture Post / Re: Wangan's 32 coupe
« on: November 03, 2014, 08:08:24 PM »
Selling this I see, what you after for the BBS's if you still got them

Stagea - the Skyline wagon / Re: 4wd and abs error lights on permanently
« on: October 26, 2014, 09:27:49 PM »
probably an abs/wheel speed sensor

General Performance / Re: 25det neo intake system problems
« on: September 07, 2014, 03:53:00 PM »
if you're going to do it it would be best to send to a mechanic all together there is nothing worse when it all comes in bits and pieces from the customer.  As for putting a ffp on it I'm not sure you might need to get one custom made or look around for a bit as I believe the greddy chinese type that you see on trademe are for r33's and non neos.

Suspension, Steering, Braking, Wheels & Tyres / Re: Tie Rod lengths?
« on: September 07, 2014, 02:23:35 PM »
yes they should be the same length

Forced Induction / Re: nistune tuner in auckland
« on: August 26, 2014, 09:30:34 PM »
+1 never go there.

I'd stay away from St Hitec when it comes to Nistune, he has no idea how it works as shown in the Nistune forums when one of his customer's uploaded his .bin file.

Timing all over the place, original VE map not even touched.....

Audio, Security and Electrical / Fuel pump voltages
« on: June 11, 2014, 09:32:52 PM »
I think stock is around 12v maybe just a little bit under, the walbro will still run fine at that.  It will just run better if its hard wired which is then around 14v.

Audio, Security and Electrical / Fuel pump voltages
« on: June 11, 2014, 07:14:50 PM »
You don't need to get that same part number just a regular relay with a fuse inline.

Picture Post / Ryeoons R32
« on: May 29, 2014, 05:20:43 PM »
i had same turbo 16psi for years no probs. External gate though so that gets a bit of the heat away.

Picture Post / Ryeoons R32
« on: May 23, 2014, 12:27:32 PM »
crack at 20psi that doesnt sound right

Suspension, Steering, Braking, Wheels & Tyres / R32 GTR diff help
« on: April 12, 2014, 11:34:09 PM »
i got a gtr subframe with hicas lock bar and fairly new noltech subframe bushes maybe 6 months old

Pages: 1 [2] 3 4 ... 33